Using the remote control with ClonerAlliance UHD Halo

The ClonerAlliance UHD Halo comes with a 433MHz wireless remote control for convenient one-hand operation. This article explains the button layout and functions.

https://s1.occld.com/image/ca/kb/ca-989uh_remote-layout.jpg

Setup

  • The remote control uses 2 × AAA batteries (not included).

  • Insert the batteries into the battery compartment on the back of the remote.

  • No pairing is required — the remote will work immediately after the batteries are inserted.

https://s1.occld.com/image/ca/kb/ca-989uh_remote-usage.jpg

Button Functions

Button

Function

Directional Keys

Navigate through OSD menus (Up / Down / Left / Right)

OK

Confirm selection in menus

MENU / HOME

Open or close the main OSD menu

BACK

Return to the previous menu level

REC

Start or stop recording

PAUSE

Pause or resume an active recording

SNAPSHOT

Capture a snapshot of the current video frame

PLAYBACK

Enter playback mode to review recorded files

Advanced Function

Long Press Right Arrow Key: When on the Firmware Version screen (Menu → System Settings → Firmware Version), long-pressing the right arrow key activates a special mode for handling certain protected content scenarios.

Operating Range

  • Wireless frequency: 433MHz

  • Operating range: Approximately 10 meters in an open environment.

  • Walls or obstacles may reduce the effective range.

Battery Life

The 433MHz wireless remote has a long battery life under normal use. If the remote becomes unresponsive, replace the AAA batteries.